Hi, after a front brake adjuster and lock ring for a M20. Can't find a part number, but it's the piece that screws into the bracket on the brake back plate. Any leads much appreciated.

Dave

email (option): jeepfinger@blueyonder.co.uk

They do come with a new cable , look on e-bay !

email (option): ianacott@hotmail.com

Thanks Ian,
I already have a new cable, got it a few years ago from JJ Cables, but can't remember if it had an adjuster, or where my old one went!! It could be a route to go though.
Just had a look on Ebay, going to go that route. Thanks Ian.

Dave

email (option): jeepfinger@blueyonder.co.uk

Hi David
JJ cables provide these fittings too for those making their own cables - I bought some recently

However - this should be on your cable fitted from new - so if you buy one you will have to remove the nipple & resolder after you fit it

Your only hope is to find an adjuster which has been made with a slot cut in it to allow it to fit the Bowden wire through it

New cable ??

Br
John

email (option): jonnyob1@googlemail.com

Hi John,
Thanks for your reply. The cable that I got fromm JJ was for the combination levers, without nipple, the adjuster slipped off and got misplaced. I ordered a new cable this morning from Ebay only to be told that the adjuster has been found!! So was lucky enough to cancel my order. John the felt arrived this morning, thanks let me know how much I owe you.

Dave

email (option): jeepfinger@blueyonder.co.uk