It's been a while, with a few fairy tales to keep me nervous.
Finally I have a V5C with a six figure registration number.
So white numbers on a black background I guess.
Just too busy at work at the moment and a building that needs a roof on before winters sets in.
The simple and nice thing about that tool I have is, I set it in my head and marked the plunger at TDC and 7/16" BTDC. It can now be used on any M20/21 as you just adjust the height with the outer hollow bolt:+1: Ron
I got my correct stencil from https://classictransfers.co.uk/ They also have the correct water slide tank transfers(cream)
"Axholme signs" Also have the number plate stencils which is where my RN tanks stencils came from. Ron
Back to the saddle
My M20 lives outside , usually under a cover but some times the rain gets to it and soaks into the seat cover.
On mine there was a piece of pressed felt between the cover & the springs that was forever becoming saturated and rusting the springs.
Sollution was some pallet wrapping so no more rust
The springs are by now ( 30 years of riding ) now quite sad, I really should replace them but to help things along I cut a piece of HDPE from the sides of a 25L chemical drum to fit on top of the springs which has made a big difference to the "Lack" of comfort when I have been caught out or have just been to lazy to lift the bum off the seat when going over potholes .
Just a thought
A couple of others with spring saddles have now done the same & all agree it works better and prevents the springs compressing groves in the padding .
The pictures all opened for me, but were a bit slow downloading? Ron
PS I'm not sure about IBB as the host that I think most of us use? , but the previous host (who stopped being free) If you deleted a picture from your albums, it would also disappear from the forum.
My pictures have links to one of my websites Ron, I thought this was the safe way to do it as I've lost many on other website using their picture posting system.
Really interesting and involving thread. However I belong to the bodge it and hope persuasion. Rick Partington had rebuilt the motor before I bought the bike and he'd opted for a low cost rebuild [motor aside]. The bloke I bought it from sold it as it wasn't any faster than his 16H.
It had the wrong engine sprocket and I knew the timing was off. He'd set it as per M21. Unfortunately the early type M21. It felt a touch flat and was so I reset it with a bit of wire and it's spot on now. I know a lot of you are perfectionists but one doesn't need to be to run one of these.
I've just had the speedo rebuilt and indicated top speed went from 64 to 81:[best tuning mod I've ever had] before it died again. Hopefully it will all get sorted....
I decided as this bike is well overdue a test ride, I'd ask Anita to hand paint the number plate.
I'm more than happy with it as a first attempt, I can't type what she said when I asked to do the fuel tank!
If I get a chance I'll wire up a brake light for a test ride tomorrow evening.
Have some sympathy for the country boys with slower internet speeds...I have to scroll away for a measurable amount of time to get to the last comment...Time for a new thread!....Ian:yum: ...
Mark how did you get the ball rolling with Dvla? I have an original reg that the bike had but long before they went digital and I've no proof of it other than the pressed plates, is it possible to apply for the war time reg or is that not an option?
Tod, without an old buff log book, you have little hope of retention of the number unless the original LVLA records survive...but government instructed them to be destroyed in the late 1970s
Do you know which county council issued your original number ? One or two ignored instructions.
Tod, I was born in Croydon, as the hospital in Purley was full. Three quarters of a century later, I'm still ashamed of it !
Regrettably, the old LCC / GLC were amongst the keenest to pulp records and none survive. You'll have to go the age-related route.
No WD motorcycle had a County Council registration number after September 1939 though, so there is no "correct" way. If you're comfortably off then you could buy a pre-war Middlesex "cherished" number and use that...or fit your plate with magnets and take it off if you think no)one is looking.
Hello Tod,
I took a torturous route with mine.
First I got it MOT'd on the frame number.
I spent too long messing around and combined with a long wait from the BSAOC getting a dating certificate the MOT lapsed.
So I don't know if that helped.
With my DVLA application I sent all the BSAOC info.
After some time I get a date for an inspection to see the bike running!
The inspection consisted of more photographs by a chap admitting to know nothing about bikes.
More weeks pass and I get a registration document for a BSA 500 !!!
Insurance, it's now a 1943 500cc Blue Star!
I know some people do it anyway, but there is no need for an MOT on an historic vehicle, whether for registration or not. Nor does the vehicle need to be running......Been there many times. Ron:relaxed:
This is my issue ron currently my bike isnt at the running stage, i wanted to apply to dvla but this states i need a proof of age which they will accept from bsaoc, i didnt know what the turn around time is for this but if its a while i can get the ball rolling now as i just joined bsaoc for this. Would be nice to ride it by the end of summer
Yes Tod as long as the bike looks fairly complete will do. They never ask to see it running. The inspector (if he's called for) is only there to check the numbers and take some pictures..... The dating letter from the BSAOC or VMCC or MVT is valid for one year. Ron