in your pic, the tube in the middle bolts together with the tube on the left with the fork crown sandwiched between em, big tubes on the bottom and the smaller on top, the holes will line up and can be a bit fiddly

barry

Barry

When I saw how much wider it was I thought there might be an issue.

So I put the two tubes against each other to see if the holes lined up. Best I could achieve was 2 holes at any point.

They appeared to be set differently.

I'll try again.

Thanks

Al

Barry

Something I didn't know. The three holes in the tubes that connect them to the triple tree are not equally spaced.

I rotated the tubes around and they finally lined up.

I also found out the extension tubes for the sliders are all the same thread/diameter, so it will be easy to source some on eBay and paint them.

Cheers

Al