That makes a lot of sense, Peter. Do you need any extra dimensions ? As you can see, the spring has been trapped and I don't have the clamp back. Apart from that it just has general wear underneath but no real damage that I can see.

That looks good to me.

Thanks,

peter.allen*55
AT
bt*open*world.Kom

Remove all three *, AT = @ and replace Kom with com.

No packers used Geoff! The lower frame rails on an M20 are 7/8" and I think those stands come in 7/8" and 1".

I also would have liked Rik's genuine BSA stand, but I'm down the queue and I wont sulk if you or Pete buy it.

Regards Ron

email (option): ronpier@talk21.com

Interesting post....I was just about to ask the same question.
It's a hard job for me to get the bike on the rear stand too particularly on frequent stops....

email (option): jmmycmullen@aol.com

Hi Rick sorry about delay in reply.
Been away.
Yes am interested if still avail.
Perhaps you could email me with price etc.
Tks Geoff

email (option): geoff.gat@gmail.com

I had one of these stands on an early BSA B31 the previous owner must have had the same trouble it had been welded on

email (option): roger.beck@node6.com

There's a sidestand on the forum picture!

cheers Menno

these clamp on stands compress the lower frame rails and often pivot on it, If you do fit one, and they can be made quite easily, pop a roll pin through it once clamped in the correct position, if I were to fit one to the W/NG, and I quite possibly will, I would try to adapt a plate for attaching to an engine plate or similar to avoid the clamp type problems.
as an aside I have had half the bottom rail of a compressed BSA A7 swing arm frame cut out, a strengthening tube inserted and the piece replaced to prevent the side stand causing the problem again. kind regards

email (option): woolnough@mchenry.plus.com