Hi,

I am looking for pictures or a drawing of the studs 66-6748 and 66-6750 to fit the pannier racks on the lower side. On most pictures there is a pannier or pannier rack what blockes the view on these studs. Yes, I looked at "www.wdbsa.nl/images/Fittinginstruction04_zpscc41f396.jpg" and the drawing of the other side.
If anyone who has the original studs can make a photo or two, I'll be happy :grinning: O, how are they fitted to the parralel studs? Or do they just hook on them?

Richard

There are 2 studs -
the stud on the near side is longer to accommodate the side stand clip & bracket
I have them NOS - but can take photos perhaps tomorrow if I make it to the unit
Br
John

email (option): jonnyob1@googlemail.com

great, thank you

just watch out for lengths, I made some in EN16T but they don't seem long enough.

email (option): pes.sales@btconnect.com

Hi Rees
I have checked here & the studs you refer to are in fact not the studs (lifting handle )I mentioned but are the lower tube stays

I have an original nos set I can measure & photo for you

I cannot post photos to this site from my mobile device - so if you can - when you receive - it can be shared with other forum members who might have similar questions

Br
John

email (option): jonnyob1@googlemail.com

Pictures and sizes

https://pesltd.uk/?product=24-5207&ptno=24-5207
https://pesltd.uk/?product=24-5205&ptno=24-5205

Mark

email (option): pes.sales@btconnect.com

FYI:

https://ibb.co/0XTghdb



png images gallery

They look nicer than the pattern ones, and yes I got the wrong bits :(

Looking at your other post, is it the studs you are after to convert plain stays to the studded version?

email (option): pes.sales@btconnect.com