Questions? Looking for parts? Parts for sale? or just for a chat,

The WD Motorcycle forum

WD Motorcycle forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: Amal 626 concentric settings


Thanks for taking the time to respond Mark.

As Ian mentioned. See picture. Mind you, it was clean the last time I saw it.....


20211124-073201

email (option): zola.industries@bigpond.com

Re: Amal 626 concentric settings

BW

What make piston are you using?

Bob

Re: Amal 626 concentric settings


I don't know Bob. Bought the piston with the barrel off a chap that were surplus to his requirements.

Thought I would freshen up the top end before putting the bike on the road.

Some pictures on the way.

email (option): zola.industries@bigpond.com

Re: Amal 626 concentric settings

Ian Wright
Assuming you are taking about M20 fitment follow the settings and jet sizes for the Monobloc carb used on later M20s as a baseline set up...It should run OK on those settings with only minor adjustments at most...Ian

This is what I have on my M21, works fine.
I mounted a bakelite manifold spacer in order to make the floatbowl go clear of the dynamo drive housing. Think it was specified as for AJS/Matchless, bought a smaller diameter and bored it out to proper size. Might have gotten it from Feked, can't seem to remember.

/Simon

Nieuwe pagina 1