If it works it works Baz. Can't argue with that. Ron

email (option): ronpier@talk21.com

:+1:

email (option): binnawan@iinet.net.au

The tapping drill for 5/16" Cycle thread is a letter J...(.276")...Nearest metric equivalent is 7mm...The O.D of an 8mm thread is .314"... So I guess you didn't fully drill it out?... Ian

email (option): ian@wright52.plus.com

Ian, I need to check that measurement, I said I "think" that it was 7.17. 9:45 pm here, I'll check it tomorrow. One thing certain, that is a strong thread. In any case that is .17 of a mm, it works good.

email (option): binnawan@iinet.net.au

OK Ian,
the drill I used was:
19/64, .288", 7.33mm
Take your pick.
Baz

email (option): binnawan@iinet.net.au

What calculator are you using Baz:smiley: I make 19/64 = .296" 7.5mm Ron?

email (option): ronpier@talk21.com

Digital caliper, not the most expensive in the world, but the drill size is definitely 19/64. Only 1/64 less than the "correct" size.
Anyhow, it works fine and I am more than happy with the bolts/nuts.

email (option): binnawan@iinet.net.au