Questions? Looking for parts? Parts for sale? or just for a chat,

The WD Motorcycle forum

WD Motorcycle forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: Supplier of original WM20 oil lines.

The 5/16" hose should be easy and the 1/4 bsp nuts and tails are available from firms like Green spark plug co, Vintage Supplies, and probably Ebay. Then hunt down brass ferrules.(I might have some?) Not sure if those exact hose clips are available or have to be made, or what crimping tool is required to give that same effect...... Stuart Bray did have some complete NOS oil lines.

https://www.vintagecarparts.co.uk/products/ca826-container-flexible-hose-fittings

Ron

email (option): ronpier@talk21.com

Re: Supplier of original WM20 oil lines.

PS. Stuart still has the complete crimped sets.

https://www.stuart-bray-motorcycles.co.uk/parts/bsa-wm20-spares/n-o-s-oil-feed-return-pipe-assembly-x2-66-8406/

Ron

email (option): ronpier@talk21.com

Re: Supplier of original WM20 oil lines.

Hi,

I have an original set. 1 is nos the other 1 is used, I will dig them up this weekend and post a few photos.

I am located in the Netherlands.

Regards,
Bastiaan

email (option): wdmotorcycles@gmail.com

Re: Supplier of original WM20 oil lines.

Some replicas could easily be made up for a lot less money!..I've done them myself in the past..Ian

email (option): ian@wright52.plus.com

Re: Supplier of original WM20 oil lines.

Yep I made mine and I think the ferrules where some that you machined to length Ian. I never bothered crimping them, I used hose that was a good fit on the tube and squeezed the ferrules on with a dab of silicon sealer. They've never leaked in all these years. Ron

M20-278

email (option): ronpier@talk21.com

Nieuwe pagina 1