I am just working around to replacing the wheels bearings and it appears they come with the internal race being the tubular shaft ! Ummh. Does anyone know what the solution to replacing bearings is therefore ? Perhaps someone has some nice NOS ? Much appreciate any advice. Thanks
Andrew, here is a NOS front axle for a G3L. I'm quite sure the axle wasn't cast or machined with the bearings in place!!!!???? and I'm also quite sure I could remove them from the axle. Have you spoken to Darren about this? Ron
Thanks Ron. Yes I am in discussion with Darren. My bearing set looks different to that in that it doesn’t have the inner race just visible on your photo. I will try to load a photo but cannot recall how upload