Last time I fitted a set of 30204 rear wheel bearings I remade the seating rings that fit in the hub under the bearing outer races to compensate for the slightly different bearing width...
I now have to make another pair and foolishly failed to record the thickness of the rings last time...(and of course I can't remember...:stuck_out_tongue_winking_eye:)
Does any forum member who has also done this modification have this dimension?...Ian
Thanks Ron...That sounds about right...The adjustment required is not very much...Comparing the width of the 30204 to the width of an original bearing should produce a similar dimensional difference which would help to confirm it...
To save me buggering around do you have the O.D and I.D. of the spacers as well?...Ian