HI All

Thought I would share a few photos on my 3HW project I am working on a at the moment
Regards

Carl

email (option): carl.chezz@cwgsy.net

Nice .. need to get some of mine published before i finish her.

Just been looking at the 3HW photos,and noticed the nearside footrest l think it may be off a later twin model,i'm not a rivet counter but thought l would point it out because the before photo shows the brake pedal at an odd angle.

The bikes looking nice!...Could you post a picture of the rear stand looking at it from the rear of the bike (if it was fitted)...

I picked up a NOS rear stand for my TRW after the original broke but it is slightly different to the one fitted....I suspect it is actually for a Triumph single..Ian

email (option): ian@wright52.plus.com

Have a look at eBay 321974018414 its a rear stand for a triumph but seller says it can be modified to fit a TRW so there must be a slight difference but I dont know what.

Pictures of mine sent to Ian.

Ron

email (option): ronpier@talk21.com

Good to see another 3HW rebuild.
There are not much around.

I remember someone wrote in The Classic Motorcycle a few years back that 3HW's were overlooked by restorers. There was not much interest in them.
Not anymore that is.

looking good Carl, finally the 3HW owners are slowly increasing.

email (option): cruaser@aol.com

I will try and upload some more photos later also

Regards
Carl

email (option): carl.chezz@cwgsy.net

Hi All

A few photos from today, Hope to get it back on the roads next week if I can get the Camo done

Regards
Carl

email (option): carl.chezz@cwgsy.net