Lost the prop stand clip plate 66-4721. Can anybody take the necessary measurements so I can make another one? Length x width x thickness, and hole spacing are all I need...

email (option): viaconsu [at] planet'dot'nl

Hans I haven't got one to hand to measure at the moment. But bare in mind it has a slight curve to it also. Ron

email (option): ronpier@talk21.com

Hans I will give it a try tomorrow.
Regards, Lammert de Vries

Hans, length is 45.2, width is 22.8, thickness is 6.3. Radius both ends R=13. Dia holes 9.2 and 8.1.
Centre line to centre line holes is 25.4. All in mm. Slight curve 4 o.
Lammert de Vries

Thanks Lammert, that's what I needed
By the way, how is your M20 progressing? Any pictures?

email (option): viaconsu [at] planet'dot'nl

They never ever came out of Small heath with those dimensions

Ron

email (option): ronpier@talk21.com

And WHAT are those correct dimensions....

email (option): viaconsu [at] planet'dot'nl

Hans I was just jokingly referring to the metric measurements Ron

email (option): ronpier@talk21.com