I have a few sets of pushrods, and I want to use a good pair for a B33 motor build.
I checked them all for straightness, by sitting them in a common V block, and checked with a dial gauge when turning them. I have one dead straight, another bent by about 5 thou, another bent about 25 thou, another very bent.
Would it be advisable to use any of these very slightly bent items,
eg (5 thou) with consideration of how they sit in and bear the load from the tappet adjuster nut.
Thanks for any advise.
Keith

Forget the really bent one, but try straightening the others by hand. Shouldn't be a problem