i can remember but did the G3L have two spacers between the engine and frame on the front lower mount (frame joint)?
thanks barry

email (option): mrsbfuller@hotmail.co.uk

one each side on the 1/4 dia long stud.

email (option): deadsheds@yahoo.com

thanks ken, just making sure.
i collected the flywheel from russell motors today, new crank pin ect and balanced and a new timing side shaft as les was not happy with the other one, im ready to put engine together now. ive got all the other G3L parts painted, i just got to put it all together and im just going to fit the engine and gearbox in the other one.
could do with getting two dynamo's if you know of any? i did buy one but it turned out to be the wrong one.

thanks barry

email (option): mrsbfuller@hotmail.co.uk

no spare dynamos barry, they are about spottd a couple at Netly but too expensive for me to buy just in case.

this is what you need to look out for

email (option): deadsheds@yahoo.com

hi chaps, spacer lengths for the primary covers, am i correct, spacer between inner cover and engine plate, 1 1/2". between the covers 7/8"??
ken that spacer you gave me is that the one that goes between the inner cover and engine bracket?
thanks barry

email (option): mrsbfuller@hotmail.co.uk

Its variable, use those lengths as a guide.
I will dig out an article on the right way to suss it all and send to your email.

email (option): deadsheds@yahoo.com

thanks ken

email (option): mrsbfuller@hotmail.co.uk