Hi
Can any one tell me the two lenths of the headlight support braces
for a 6 1/2" light on a 42 wm20 and were thay made out of 7/16 tube

Has any one found a supply of 7/16 tube in Austraila QLD

Regards
Michael Hughes

email (option): michael@nammech.com.au

It has been illegal to supply tube in imperial sizes since we went metric

email (option): wariron@tpg.com.au

It should be easy to turn down a bit of 12mm tube to the 11.11mm ( 7/16 )

I will have a measure tonight and try to get some dimensions posted for you.

I have just bought a set of repro headlight braces, so they should be the same.

Darren

email (option): dwrudd@lineone.net

hi,check out ebay 280969281704 ready made. this guy also does mudguard stays and the canvas grips ,also pillion seat covers
cheers rick

email (option): richardholt@rocketmail.com

I have a set originals for that amount.

Henk

email (option): ahum@quicknet.nl

Hi I was given 115mm and 125mm hole centers, is that corect and the long one to the bottem
Regards
Michael Hughes

email (option): michael@nammech.com.au

I made some up with 125mm centers top and bottom. I got the size by scaling off drawings. I know the top ones seemed slightly shorter but I put that down to the fact that I was not looking at a true length on a flat drawing. I used flat bar for now and plan to remake them using 12mm stainless steel hydraulic tube.

email (option): pvlietstra@gmail.com

I think you will have to shout louder Henk

Ron

email (option): ronpier@talk21.com

email (option): ahum@quicknet.nl