Hi All.
HELP.
On my rebuild, I have got to the stage of fitting the oil tank& battery carrier and I cannot think for the life of me whether there should be spacers on the plate that holds the carrier to the frame, also what is between the carrier and the tank to the rear of the down tube. any diagrams or photo's of this would be very much appreciated.

Kind regards TTJohn

email (option): Jomichael@aol.com

Me too John. When I took it apart, there was a mish-mash of nuts and washers acting as spacers and I'm keen to see what, if anything, should be there

email (option): lee@twowheelstested.co.uk

On the midleplate are some weld rings and a nut. behind the oil tank are 3 litle bush spacers do you want some pictures of that ? Gr Theo

email (option): oldbikes@kpnmail.nl

russels had loads of the spacers last time i was in ?

email (option): chris.astinbarker@btinternet.com

That'd be great Theo, thanks.

email (option): lee@twowheelstested.co.uk

Theo.
A picture would be very much appreciated, I look forward to it, you can either post it on the forum, or send direct to my e-mail address.
Many thanks.
TTJohn

email (option): Jomichael@aol.com

Check the technical page. I think I got my rough drawing from there. The length is .410 inches.

email (option): britool51@hotmail.com