What thread are the bolts for rubber knee pad on BSA m20
Hi. Just a quick question what are the thread pattern of the 1/4 inch bolts that hold the rubber kneegards on for the BSA? Also I looked everywhere but couldn't find the info anywhere. Did I miss it?
Re: What thread are the bolts for rubber knee pad on BSA m20
Yes, the original screws were Cycle thread so the thread angle would be 60 degrees as Robb indicated.
BSF is commonly referred to as an eqivalent to cycle thread at 1/4" diameter (where the TPI are the same) but although it is useable, that is not strictly the case...Ian