Henk, I take it that the jet blocks are the 'R' type ? If not (ie Norton type) then I'd like a couple.
Is the HT lead complete with plug ? If the lead is one piece (ie no immobiliser or suppressor) and has a plain fitting (no KLG cap) then I'd be interested in knowing the price.
The bottom end looks like a REME rebuild. Did this lot turn up in The Netherlands ?
What size and make are the box spanners by the way ?
Hi Henk..I'd like 2 main bearing spacers, 2 crankshaft nuts (drive side) 1 engine shock absorber spring, 2 oil pump drive spindles and cam followers...how many of those have you got?...mail me please with prices...Ian
hi henk,im interested in a pair of oil pipes a cush drive a 3'' petrol cap a damper knob and a front footrest cheers rick ps if those are oil filter caps hiding at the bottom one of those also
Henk,
If these jet blocks are of the norton type then I would like one too!
Can you also send me prices for the regulators and the ht lead cable?
Do also inform me about size and make of those box spanners of yours...
The mudguards are indeed for sale. They need quite a bit of work done on them but they can be fixed. The (flat) rear mudguard is actually in a pretty good condition while the tailpiece (with centre ridge) needs quite some work as does the front mudguard. I want 150 euro for this lot.
As far as I know this is an Impire Star gearbox from about 1938/39 and it should be more or less complete and it's for sale.
Henk.
Hi Henk
By coincidence I was talking to someone at Beltring (can't remember who though) who had just bought an outer cover like that for his WD M20, I wonder if it will fit?
Silly me, what is sleeve nut? I have two front fork springs, one new in the box one that could have seen some use but still has the full length. Both are for sale.
Hello Henk
I am after a empire star outer gear gearbox cover, it looks like you have early and late
Also the oil lines from the tank to the crankcase and the top dampener knob,
If they are for sale
Cheers Darren
hi henk
do you have rear section rigid frame m20 and how much for the right hand side breather complete, also what about the spacers that fit between the rear section and how much for the good looking cylinder head
mark
I can't help you with a rear frame I am afraid. I probably have a complete breather for you. I guess a complete breather with pipe would cost about 35 euro.
Hello Henk
I was after either of the two covers, the painted one or the one up on top of the boxes, are either of these available or the oil lines or dampener knob ( the top one on top of the yoke), is there any top fork links hiding in the boxes?
Thanks Darren
Hi Henk
Do have a speedo ,complete or even one as parts . i do have one but has a broken balance wheel. i could build one out of parts. Also looking for a tail lamp and the rear mud gaurd if its a good one. complete tool box would be good too.
Dit noem ik een snoepwinkel. Ik heb belangstelling voor een buitendeksel van de versnellingsbak. Die van mij is gelast en niet helemaal vlak dus olielekkage plus speling op het gat voor de kickstarter. Heb je misschien ook een carterplaat
Ik hoor het wel.
Hi Henk.Been in touch with Ian re 600cc to 720cc,more pistons comming.I just seen the stuff you have for sale from July add.How much for the girder forks if you still have them.Cheers Drew