Just rebuilding my bsa wm20. I have a spacer and I am not sure where it goes. It measures 10mm bore size, 6mm thick and 24mm wide.
My two options for this spacer are:
1. Is it the front engine plate, right hand side between engine plate and rear sub frame or
2. Is it rear brake adjustment plate to the frame?
Does anyone have any ideas which one it is.
Cheers
Richared
Hi Richard..could you clarify those dimensions?..inside diameter is 10mm (so it fits over a 3/8" stud). Could you give the figures for outside diameter and length?...Ian
When the sump guard lugs are missing (new type sump guard) you need a spacer at front bolt side. Or use a new shorter bolt. My frame also has a spacer.
Lammert
The front frame stud is 7/16" dia. (11.09mm). So the spacer described wouldn't fit there with a bore of only .394" (10mm). Unless an undersized stud has been used...Ian
Can you send a pic of what it looks like on the bike?
I don't know if you are looking at the bike from the front, or sitting on the bike looking at the front.