Hi I am trying to fix the valve lifter assembly but I am unable to do it. I am not sure how the cable fits to the lifter. I would be grateful if someone can send me a closeup pic of the assembly. Thanks and Regards
Henry this is how mine is. They are not the easiest to set up! You must make sure you have a little bit of clearance between the lifter and mushroom head on the exhaust valve. The end of the engine stud that the adjuster fits too is slightly bent up to give some clearance between the adjuster and crankcase..... Not one of BSA's best design developments. Ron
Thanks a lot for the pics. I never thought the cable should be fitted from under the valve . Tried a lot of combination's/Trial-Error this morn and nothing worked. Will head out early tomorrow to get this fixed. Thank you so much once again.