Hi all,

I've fitted sealed steering bearings to my WM21. The top faces of the inner and outer races are flush / level. My query is, do these need a thin spacer / washer for the inner races, to allow the top and bottom yokes space to turn?

Hope this makes sense.

Regards,

Craig

Hi Craig...I've sent you an e mail with an attachment detailing the full fitting instructions for the sealed ball bearing conversion....Ian

email (option): ian@wright52.plus.com

I had to do just that with shims to mine. It's a nasty experience when the top yoke rubs on the outer race:scream: Ron

email (option): ronpier@talk21.com

Thank you both; I thought I was missing something. Looks like a couple of thin shims are the solution...

WM20 2966 is coming together slowly with a lot of help from you all.

My regards,

Craig

A bit of a saga on the subject if anyone is interested.

http://pub37.bravenet.com/forum/static/show.php?usernum=3155626639&frmid=16&msgid=1448720&cmd=show

Mark

email (option): pes.sales@btconnect.com

Hi Ian,
Would you be kind enough to also share your fitting instructions with me? I'm also about to fit sealed headstock bearings.

Regards
Shane

email (option): shaneambrose@hotmail.com

Hi Shane..email sent...Ian

email (option): ian@wright52.plus.com

Thank you Ian, greatly appreciated

Regards
Shane