Questions? Looking for parts? Parts for sale? or just for a chat,

The WD Motorcycle forum

WD Motorcycle forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: tight clutch and gearbox - M20

I have reopened this thread as now completely clueless on this matter. Bear with me.

1) Fitted, removed, and refitted clutch complete, not when the clutch nut not fitted, inner clutch turns, however primary chain does not, and can do this on the kickstart. Engine when chain not fitted turns sweet. Surely the chain should turn?

2) Fit clutch nut, and kickstart locks up, no give at all, clutch, chain etc no movement at all!

I am now at wits end and followed the book and advice on here three times now, can anyone help with this bloody issue!

Thanks in advance.

Danny

email (option): dannyburt152@gmail.com

Re: tight clutch and gearbox - M20

This has been going on a long time Danny.
Do you have anyone close to you that knows what they are doing?

Mark

email (option): pes.sales@btconnect.com

Re: tight clutch and gearbox - M20

My guess and it's not a very good guess but here it goes.

I suspect when you fit the clutch nut and tighten it and now nothing will move anymore is due to the gearbox main shaft being pulled over to the clutch side. This will lock up the ball bearing on the other side. It could also be from the clutch sleeve being locked up against the output sleeve gear.

Does the clutch sleeve lock on to the main shaft taper properly or does it run in to the sleeve gear? Try fitting it and the nut without the rest of the clutch and see it it turns.

Are both the taper on the shaft and the taper inside the sleeve gear OK?

Do you have the correct size clutch rollers? If too long it will lock the clutch.

If your Burman expert has never worked on a M series BSA gearbox, I bet it was assembled wrong.


Without seeing the bike, that's all I can think of.

Re: tight clutch and gearbox - M20

Bruce has mensioned this in one of his anwsers.
Before you blame the gearbox, check that when you tighten the main shaft clutch nut that it is not locking the clutch chain wheel to the centre hub. With the nut tight and no plates fitted you should be able to spin the clutch drum and hold the centre without any drag.

Nieuwe pagina 1