I think most MAC's had a 276 with a 15/16" bore as opposed to the M20 1" bore (John will probably confirm) And the bottom nut, slide, main jet are different, but very easy to swap from your old carb or buy new from Amal or Hitchcock's. Or look up "Joe the carb" (in UK) for a complete refurb. At the least, the flange will need checking and truing for flatness. Ron
As usual Ron is spot on Velo Mac had 15/16 of an inch where the air goes in and 130 main jet and 6/3 throttle slide where M20 had one inch and 170 and 6/4.
So the carb is definately a 276C/1B this is stamped in and it measures a perfect 1" bore except from at the end which is clearly distorted, i am going to attempt to ream this to a better shape. Unsure why it has velo mac wrote on it though
OK, I wouldn't worry too much about the oval bore at the flange end. The bore in the cylinder barrel is usually bigger anyway as the same barrel is used for an M21 which has an 1 1/16" carb.
Most important is to get the flange flat if it's been distorted, by taping a sheet of W&D paper to a surface plate or piece of plate glass. With water, circling motions and some patience it's soon done.
