Thank You ,
I aim to preserve the red "tell tail" pendant .
I cant even open the body up yet as I cant close My fingers around a screwdriver ..I know all the internals are present on all 3 lamps but dont know how the pendant is attached into the body yet ?
Just had a thought (rare) but how would You be able to see the "tell tail" ..is way out of vision on the bike I think ?
I have 2 bodies
1 x mazac
1 x chromed brass
1 x white Lens
1 x painted red white Lens
1 x mint original red Lens
Some repro lucas red top pennants
1 x nos Lucas red pennant
Some Lens securing screws in st steel I think
These are surplus to my requirements at this time - would prefer to unload as a lot - swaps considered
I'm attempting the above conversion of a 1130 car side light. I want to rivet a clear bottom lens in place. Any suggestions for the best type of plastic to use -something that'll not go brittle or yellow too quickly?
I think that I'd try a piece of Lexan polycarbonate cut from an old helmet visor. Modern visors are probably too thick, but the seventies examples were thin and flexible.