Questions? Looking for parts? Parts for sale? or just for a chat,

The WD Motorcycle forum

WD Motorcycle forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: What are the fuel Tap threads on a '41 M20

Hi Ian, I’ve just got a pair of eyes, attached to a 24 year old, to double check the pitch. You’re exactly right, it’s 20tpi! In my defence it was 05.55 this morning when I dropped the pitch gauge on! The early hour and my newly acquired ‘special Austin fuel thread’ info. Made it seem like 19tpi was spot on.
In conclusion, the 7/16 diameter and 20tpi must make it BSC coarse, as you told me it would be, thanks. My two fuel taps have the same thread on their outlet also.
Thanks for clearing it up,

Tim.

email (option): timmykins@icloud.com

Re: What are the fuel Tap threads on a '41 M20

Just to confuse matters here, Draganfly list an Enots type tap for the 1940 - 1947 'M' series as 1/8 upper x 3/16 lower and state that all sizes are BSP. 3/16" BSP seems to be an obsolete vehicle size that was never an industry standard.

https://draganfly.co.uk/product-category/bsa/sparesparts-for-bsa-a710-b3133-c101112-m202133/oil-petrol-tank-abcm/petrol-taps-pipes-abcm/

On the basis that BSP is often given as dimension + 1/4", both 3/16" BSP and 7/16" would have a .4375" OD and it would seem likely that the BSP thread would be 19tpi as per 1/4"....A brass thread of 19 or 20 tpi that has been forced could easily give a misleading measurement.

Re: What are the fuel Tap threads on a '41 M20

So......I’ve checked my fuel taps, the thread on the outlet side is 7/16 x 19 tpi. The thread on the crank case breather outlet is 7/16 x 20 tpi.
In conclusion then, the breather thread is 7/16 bsc coarse and the fuel tap thread looking to be the elusive 3/16 bsp. Possibly adopted as a brass saving measure and used on, amongst other things Austin 7 fuel systems.

email (option): timmykins@icloud.com

Re: What are the fuel Tap threads on a '41 M20

Enots used a special thread for the pipe fitting 7/16 x 19 TPI.
This from RudgeWhitworth.com website.


Re: What are the fuel Tap threads on a '41 M20

It would seem though that the lower fitting has a 60° female taper as per BSP....so if it was unique to Enots then it followed BSP conventions.

Some careful examination is called for to check if it has a 55° thread angle. If so then it is likely that Benton & Stone created their own intermediate 3/16" BSP size....

Re: What are the fuel Tap threads on a '41 M20

For my breather pipe, which thanks to Ian we’ve established is BSC Coarse 7/16 diameter 20tpi. I only managed to source a 7/16 diameter 19tpi fuel pipe union (the ones that fit the Enots fuel taps, also discussed in this thread).
Using a 1.25 pitch metric thread file (60 degree thread form like BSC, much cheaper than a BSC thread file and has got me out of trouble with lots of BSC thread issues) I’ve ‘eased’ the thread in the union. So it now screws onto the breather with slightly more effort than my sausage fingers can produce. I’m happy with this compromise. Once my workshop is built and I have bought a lathe, such things will be a thing of the past!

email (option): timmykins@icloud.com

Nieuwe pagina 1