I ordered a set of clutch rollers from Draganfly, they supplied quite openly labeled 1/4 x 15/64 rollers. What is the expert opinion on this as compared with 1/4 x 1/4 please?
Pete is right. Triumph rollers MUST be 10-12 thou shorter or the clutch wont work properly. I guess Drags are supplying one size fits all.
I buy best quality bearings from forum member Darren Wrudd. Ron
Yes, they must be 1/4" x 1/4" for the BSA..Draganfly have had this incorrect listing for a while, I recall this has been discussed here previously....Ian
Thank you everybody for your answers. I ordered the rollers from draganfly definitely for an M20 clutch. I have a couple of other sources here in Australia that I will try first. Once again thank you. Dave.
I have hundreds of Hoffman rollers even in oversize.
In the States though. Can send 1st class mail affordably.
Dave, I've PM'd you. Please send address and I'll kit you up.
check and see if you need oversize. My chapter on the clutch
is here in the tech section, or I'll send one to you.
Thanks for your help with the Carby codes mate! I owe ya!
