Hi all I'm looking for some info on the front hub spindle locknut washers in the parts booklet shows three washers one small one goes against the bearing nut then the speedo drive then is it the other two washers then the locking nut , I only have one larger washer anyone know thickness of these please. Phil

email (option): Sportsterphil@hotmail.co.uk

The sequence is as you describe it. The small washer fits in a recess in the speedo drive to stop it being crushed. The big washers are each about 1/8" thick. Ron

email (option): ronpier@talk21.com

Phil, I have these dimensions written down as being:

36-3528 - 0.640"x 1.25"x 0.125" (1/8" thick as Ron said above)
66-5524 - 0.640 x 0.950" x 0.078" for the one inside the speedo drive.

This came from a discussion on the forum years ago - at the time there was discussion around the quantity of the 1/8" spacers as I think it was Russells who listed one while other parts lists show two.

Thanks Ron and Ray for the info

email (option): Sportsterphil@hotmail.co.uk