Re: Brass contract plate position on WM20 rear guard?
Some early contracts had it on the rear number plate, rear light bracket or another on the side of the tool box, and even after it standardised on the removable rear section of the mudguard its position could have varied with different contracts, I assume all the holes were punched or drilled using a jig so a measurement from a another machine from your contract should give an accurate position.
The only example I have is this late one with a steel plate, I can dig it out and measure it if you want, I think I know roughly where I have stashed it.
Re: Brass contract plate position on WM20 rear guard?
David,
Mine, from 1944 of the same format as Rob's above, is located with the rivets at 5.5" below the top edge of the detachable portion.
Regards, John