HI,
Can anyone tell me the measurements of these, I plan on making a set out of hex bar as I'm not paying £32 from the only place I can find them!!
I'm guessing 5/16 BSC thread and 1/2" bar but...
TIA
Scott

email (option): larkesrATgmail.com

Anyone out there can help me out with this please???

TVM
Scott

What make of bike??? every make was different!

Cheers,

Lex

email (option): welbike@welbiXX.net (think about it!!)

Sorry Lex,
Wm20

I just found a M20 one in a box of bits:

Hex is 0.600 (15.2mm) - long 3/4"

one side has a 5/16" BSC stud with a length of 18 mm

the other side should have a hole with the same 5/16" thread.

Cheers, Michiel

email (option): m.wijbenga@hotmail.com

Thanks Michael,
Exactly the detail I was after, time for a bit of proper hand skill engineering!😀
Regards
Scott

This might help.

email (option): mfarnay@bigpond.net.au

Certainly does Mark, thanks for taking the time to draw that. Just need to find some hex bar and I’m set!

Scott

Don't thank me Scott.
This came from Ray S.
Thanks Ray.

email (option): meck04@bigpond.com

Scott
I have made some if you need

email (option): Darrenacartwright@yahoo.com.au

Thanks for the offer Darren but I've already ordered the hex bar!🙄
Hopefully be able to have a few sets spare if anyone is interested, they won't come covered in 60 year old cosmolene though (and they won't be £32 a pair either)!:slightly_smiling_face:
Scott

email (option): LarkesrATgmail.com