Hi, so I have had my M20 for some months now. I have a few questions, my bike is difficult to start after it has been running for a while, is this normal? Secondly, I have been too busy to ride it for over a month and I now find a huge oil pool in the drip tray (the oil tank is almost empty), any suggestions what to tighten. I realize they do leak oil but this is excessive I think. it will need tightening up as it is almost at its first 1,000 miles since restoration, what is likely to need the most attention.
Thanks for any help.
Joe I'm fairly certain that your bike has "Wet Sumped" Which means while the bike has been standing for a period, the oil has seeped past the oil pump and ended up in the crankcase. Ultimately it will leak through the main bearings and into your primary case. Before you attempt to start the engine, remove the drain plug in the bottom of the sump and allow the oil to drain into a clean tub and return it to the tank. Also remove the level plug from the primary case to get the level back to normal.
One thing to do to try and avoid a repeat, is to remove the small hex plug near the bottom of the timing cover, where you will find a light spring on top of a ball bearing. Squirt it all out clean and give the ball a light tap with a punch to create a good seat. (better to buy a new spring and ball for a couple of quid. Also start the bike up more frequently will help.
If your bike starts ok when cold but not when hot, it's almost certainly that the magneto requires an overhaul. Ron
I am struggling to get a 3/16 ball and suitable spring from my usual supplier. I thought i may try a new one to see if it stops my m20 wet sumping. It cant be a coincidence that it started wet sumping the last time i removed the timing cover and the oil valve spring screw. Wonder if the ball bearing can just fall out and ive lost it ? Would it damage the engine if teh non return valve effectively didnt work ?
Is it ok to use a generic 3/16 ball bearing off ebay or can you recommend where i can get the correct item.
It's a 1" bore x 1/8" thick (or metric equivalent) .....90182 from here http://www.hitchcocksmotorcycles.com/amal-carburettors-miscellaneous
or the heat insulator gasket.