Comment
Sam the later 16H's had 7/8" bars!
Here is a scan from a 1944 M20 parts list showing the standard Amal levers. The choke and mag levers are curved and have a ball end and not the flat end. Ron
upload image
email (option): ronpier@talk21.com
Samuel Cormier
Horror
Hi Cas, I would say your front brake lever and mount are Norton 16H, looks just like the one on my Norton.
Getting lever fever is a bad illness and can take a long time to cure and it's not cheap unless you're lucky
Getting lever fever is a bad illness and can take a long time to cure and it's not cheap unless you're lucky
Only problem would be the 1" vs 7/8".?
Late war and civvie bikes were 7/8"
email (option): horror@blueyonder.co.uk
Just returned from Wuxi in China today and the first of two packages was sitting there with four sets of NOS levers. When I receive the rest I will contact all parties whom requested some. They are covered in thick grease but I will leave them for the new owners to clean up.
email (option): deepsea@vol.net
I can also get these levers NOS
email (option): deepsea@vol.net
Stuart Woods
Just returned from Wuxi in China today and the first of two packages was sitting there with four sets of NOS levers. When I receive the rest I will contact all parties whom requested some. They are covered in thick grease but I will leave them for the new owners to clean up.
AAHHHH, I must be drunk
Amazing find, I would be in the queue if I hadn't a spare set. These levers work great, especially the valve lifter, much and much better than that stupid little thumb lever that pricks into the tank.
email (option): m.wijbenga@hotmail.com