Questions? Looking for parts? Parts for sale? or just for a chat,

The WD Motorcycle forum

WD Motorcycle forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: Clutch dragging

Well it doesn't really matter Noam. But what I meant was, remove the first two plates you come to. So the ones on top of the stack. I agree it's an arse to have to undo it all, but well worth it in the end. Ron

email (option): ronpier@talk21.com

Re: Clutch dragging

Thanks again dear Ron !

Noam.

Re: Clutch dragging

There's a piece I wrote about clutch problems in the technical section as well...It covers 'drag' and 'slip'...Ian

Re: Clutch dragging

Noam


The only down side is to re-open it all now,
After it was all sealed, and my primary cases are with oil...



Hi Noam, don't know how you seal your primary cases but using grease instead of silicon for the corkgasket saves you a lot of meshing and time.

The grease keeps the oil well in, works great for me. Kind regards, Michiel

Re: Clutch dragging

Thank you Ian,
And I will definitely check the article on the tech' part.

Michiel, thanks for the advice.

Actually I dipped my finder in the bike's oil tank and smeared oil
Over the 2 sides of the cork gasket.
As far as I can see now, after a week or so- all is well. no drip.

Generally, where sealant is needed, I do not use silicone on the bike.
I am a great fan of Shellac. I use "ABRD" Eagle Shellac.
I like it better than silicone. it's very sticky,(Try to get it of your hands...)
thinner then RTV/silicone in texture, and it does not tens to tear off and get into your oil circulation
Or anywhere else, if you have a build up of an access material in the cases..

Cheers,
Noam.



Nieuwe pagina 1