In the process of fitting magdyno. The previous owner did not shim the magdyno out enough and the drive side magdyno bearing took a beating from too little clearance. It had .015" of shims when I removed it. The base of magdyno and engine platform are not worn at all do to very little mileage since bike was new. Adding another .010" of shims was better but still a bit too tight. Adding another .005" and all seems OK with a small amount of gear backlash so now at .030" shims total. Is this considered excessive or normal to need .030" of shimming?
Now another issue, it appears I have no hope of the oil seal working as the mag shaft is now not even close to being concentric with the seal hole now?