Hi, Is the Girder Fork Washer plate (Part Number - 24-5237) an important part? Tried the whole of google for an image and I could not find even one. Does anyone have a picture of this plate?
J.M

John it's #24 in this image. It's just a large flat washer the same diameter as the bottom spring scroll with a 3/8" hole for the stud to pass through. Ron

email (option): ronpier@talk21.com

email (option): rays54@hotmail.com

Even better! I forgot about the locating dowel hole and was not about to dismantle my forks to look Ron

email (option): ronpier@talk21.com

Ron, I wasn't sure how far that pin protruded and was just out in the shed digging out a set of fork blades to check.
The pin does locate in the fork itself so protrudes through the washer. I just measured a washer at 0.102" but that is dirty and rusty so the original would be a hair thinner.

email (option): rays54@hotmail.com

Ray I rekon if John puts a Half Crown under a 100 ton press, it will be just the right size Ron

email (option): ronpier@talk21.com

Hey All thanks so much. Looks easy to make one. The only thing is that I have to get the right size. What will be the approximate thickness of the washer?
JM

John - that was the 0.102" reference (but not very clear I'm afraid).

email (option): rays54@hotmail.com