hi chaps. went to fit both of the fuel taps to the tank which are both normally 1/8 fitting, one tap screwed in as it should but the other side seems to have a slightly bigger hole, it doesant seemed to have been bodged or re threaded, its not 1/8 and 1/4 is to big, is there a size inbetween and has any one had the same issue?

thanks, barry

email (option): mrsbfuller@hotmail.co.uk

tap them both out to 1/4 bsp and fit decent taps

They was just one tap, the other just has a banjo bolt and a link pipe going to the tap on the left hand side

email (option): davmax@ntlworld.com

which is ok for the rivet counters but a real pain in the arse when you need to get the tank off

The whole tank is a pain in the ass to get off regardless of the tap!!!!

email (option): davmax@ntlworld.com

i know they had a banjo fitting but never looked in to em.
ive just found a brass adapter that fits tank and tap nicley,

thanks, barry

email (option): mrsbfuller@hotmail.co.uk