I am transforming an old, wrong-turning speedo drive into a right-turning one, using the innards of a post war one that was used on my Triumph '21' .
But now I need those tine rivets, about 1.6mm with sunken head. Yes, they are available, 1000 in a packet, sufficient for 250 speedo drives, but I only need four
Anyone

email (option): viaconsu [at] planet'dot'nl

Try Sapphire products at www.sapphireproducts.co.uk they may sell you just the amount you require

email (option): davmax@ntlworld.com

You can make them yourself if you have vices, little hammer, and piece of mild steel wire

email (option): kalle.tikas@gmail.com

If it helps Hans I will take 4, Rob

email (option): robmiller11(a)yahoo.co.uk

Thanks Dave! I found the website but is was 'non-clickable'. But an email solved the problem.

email (option): viaconsu [at] planet'dot'nl

Yes Kalle, that's another way to get them, I did this before!
Hans

email (option): viaconsu [at] planet'dot'nl

Hans WDM20 58764

I am transforming an old, wrong-turning speedo drive into a right-turning one, using the innards of a post war one that was used on my Triumph '21' .
But now I need those tine rivets, about 1.6mm with sunken head. Yes, they are available, 1000 in a packet, sufficient for 250 speedo drives, but I only need four
Anyone

email (option): tehd@live.nl

Bedankt Ted, ga ik proberen

email (option): viaconsu [at] planet'dot'nl

Hans,

Those places usually only have aluminium rivets, but you could try, there's a good one in Barneveld. I have a lot of countersunk alu. rivets too here, all ex british airplane stuff.

Have an M20 rear stand from Ron for you here, will drop it off when I'm near.

Cheers,

Lex

email (option): welbike@wel***.net

email (option): viaconsu [at] planet'dot'nl

Neeeee,

http://www.detelefoongids.nl/rem-en-frictieservice-g-van-ee/wp54436393/9-1/

Cheers,

Lex

email (option): welbike@wel***.net

I have a box FULL of all types and sizes of rivets, brass, steel, alloy, etc............mostly all ex-WD NOS.............there are some very small rivets in there from memory........

Just need to remember where I put the box !

I just use cutoff flatheaded nails.