a pair of the gearbox serrated washers they would like to part with ?
part no 65-4189

ive tried the usual suspects, Drags and Russells, but both say no...

pretty please ?

email (option): chris.astinbarker@btinternet.com

Hello

Fits a amal 376 monobloc 1" also for a M20? Or just the Amal 276C/1B.

Thanks for your answers.

BR, Mitja from Slovenia

email (option): mitja.peterka@siol.net

from my list

Monobloc 376
Choke 1 inch
mainjet 240 (with filter?? anyone)
Pilot jet 30
slide 376/5
needle position (from top) 3
needle jet .1065

Cheers
Pete

email (option): petercomley@web.de

Pete Thanks a lot

Mitja

email (option): mitja.peterka@siol.net

c'mon chaps...

its only a littel bit ?

email (option): chris.astinbarker@btinternet.com

Hi Chris..With a little modification you can use the swinging arm serrated washers. If memory serves, the hole in them is 5/16" (as opposed to 3/8" on the M20) so they will need to be drilled out. You will also have to get them faced off on the non serrated side to reduce the thickness to suit the available space and M20 stud lengths...S.Arm models have one washer as part of the bolt and the other one loose so you need to ask for 2 of the loose ones.
However, on the up side you should get a pair easily enough from one of the Goldie people or perhaps C&D Autos, Kidderminster motorcycles, Draganfly etc etc..Or you could look on ebay....Ian...

I still have a few of them. I'll be away until Sunday to a BSA meeting.

Henk.

email (option): ahum@quicknet.nl

Pete,

There should be a filter on this carb ( with the 240 mainjet) according to the Haynes workshop manual.

John

email (option): john.kater@chello.nl

I run a 626 on mine which runs really well spaced out with the inlet from a B40.

email (option): wariron@tpg.com.au